07947 708446

BMW M140i B58 custom Z-pipe cat-back exhaust

One 3.5-inch pipe at the front, two 3-inch pipes at the back, and a hand-built Z-pipe between them. Here’s how the Pi Motorsport workshop fitted it all under one BMW M140i.

Pi Motorsport, Birmingham
Jump to the build specification
Black BMW M140i on a lift showing its custom underbody exhaust and twin tailpipes
The finished cat-back on the lift, from the centre pipework to the two rear outlets.

The brief was to give the B58 a different voice

The owner wanted a sharper, more aggressive exhaust note and a layout that felt distinctive to this M140i. Their car arrived with a 4-inch downpipe already fitted. We used that as the starting point for a large single front pipe and let the layout split further down the car. The team reviewed the B58’s twin-scroll turbo arrangement while deciding where the new pipework would begin.

The exhaust was one part of a longer-term project. The owner is aiming for roughly 650–750 bhp with a future hybrid turbo and supporting modifications. That figure is their target for the wider build.

Fitting the Z-pipe into the transmission tunnel

The tight spot was where the 3.5-inch front section needed to divide into two 3-inch pipes. The tunnel still had to accommodate the bends and leave room around the heat shielding and nearby hardware. The workshop combined tight-radius mandrel bends with pie cuts, positioning each section on the car as the route took shape.

Once past the Z-pipe, the two pipes run separately to the back. V-band clamps join the new front section to the existing downpipe and let the rear sections separate from the mid-section. Both runs finish in 4-inch gloss-black tailpipes.

Single front pipe splitting into two welded pipes beneath the BMW M140i
The single 3.5-inch front section divides into two 3-inch pipes.
Welded Z-pipe mid-section beside the BMW M140i’s underbody heat shielding
The Z-pipe follows the contours of the transmission tunnel.

What the finished M140i sounds like

The workshop describes the finished note as higher-pitched and raspier, with the change most apparent under acceleration. The system has no silencers, resonators or valves, so the owner chose one fixed sound character. If you’re planning a similar project, tell us where you use the car and how you want it to sound at cold start and on longer drives.

Hear the M140i on TikTok

Build specification

Engine
B58 3.0-litre turbocharged straight-six
Existing downpipe
4-inch (102 mm), retained
Front section
Single 3.5-inch (89 mm) pipe
Mid-section
Custom Z-pipe, with a single-to-twin transition
Rear section
Twin 3-inch (76 mm) pipes
Connections
3.5-inch V-band at the downpipe and 3-inch V-bands at the rear sections
Mounting
Stainless-steel brackets
Sound control
Fixed system without silencers, resonators or valves
Tailpipes
4-inch gloss-black Akro tailpipes
Explore custom cat-back exhausts

A closer look underneath

Twin rear exhaust pipes routed around the M140i rear differential
The twin rear pipes run past the differential and out to opposite sides of the bumper.
Close-up of welds and a V-band clamp joining the mid-section to a rear pipe
One of the 3-inch V-band joints between the mid-section and rear pipework.
Parallel welded centre pipes and a stainless hanger on the BMW M140i
The stainless bracket meets the car’s rubber exhaust mount.
Angled underside view of the finished M140i exhaust and tailpipes on the lift
From the rear, each pipe can be traced to its own 4-inch tailpipe.

Related workshop builds

Planning a custom exhaust for your BMW?

Tell us your model, current exhaust and what you want to hear from the car. We’ll talk through the options before you book.